HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.0 Mainframe Agent Installation and Configuration Guide (TB581-96014, November 2010)

However, if all Information Store names within the storage group that is the restoration target have
been specified, you can restore backup data even without specifying the -recovery option.
If the -recovery option is not used to restore a backup obtained by cold backup, the -recovery
option cannot be used for backups obtained after the restored cold backup.
-pf copy-parameter-definition-file
Specify this option when using the number of retries and the retry interval defined in the copy parameter
definition file. Specify only the file name, without specifying the path.
When you omit this option, the value of the RAID Manager-linkage definition file (DEFAULT.dat) is
used. The value of the RAID Manager-linkage definition file (DEFAULT.dat) is used for parameters
that are not coded in the copy parameter definition file.
Create the copy parameter definition file with an arbitrary name in the following location. Specify
the file name using alphanumeric characters totaling up to 64 bytes.
Application-Agent-installation-directory\DRM\conf\raid
-vf VSS-definition-file-name
This option specifies the VSS definition file used at VSS backup. You can use this option only when
restoring backup data that was obtained using VSS. If you specify this option when restoring data
other than backup data obtained using VSS, it will be ignored.
For VSS-definition-file-name, specify a file name only. Do not specify the folder name. The VSS definition
file specified in this option must be stored in the following folder:
Application-Agent-installation-directory\DRM\conf\vss
If you omit this option, the command uses the following file as the VSS definition file:
Application-Agent-installation-directory\DRM\conf\vsscom.conf
-ef Exchange-environment-setting-file-name
Specify this option to change the parameter used for linking with Exchange Server each time a
command is executed.
For Exchange-environment-setting-file-name, specify a file name only. Do not specify a folder name.
The specified Exchange environment settings file must be stored in the following folder:
Application-Agent-installation-folder\conf\exchange
If this option is omitted, the default value is used.
Note
• The backup information in the backup catalog is managed based on using the copy group as a
key. Depending on the backup method, you might not be able to perform restoration, even though
the backup data exists on the secondary volume.
Note the following when restoring backup data obtained using VSS in units of Information Stores:
• When restoring backup data in units of Information Stores, if you specify both an Information Store
name and a storage group name, operations will occur as described below:
CLI Reference Guide 209