HP StorageWorks P9000 Tiered Storage Manager Software 7.1.1 CLI Reference Guide (TB585-96014, September 2011)

# cacheMode=Unknown
# IOSuppressionMode=Unknown
# xpThinProvisioning=-
# arrayGroupBusyRate=
# arrayGroupMaxBusyRate=
# targetControllerDeviceNumber=00:0A:02 * (00:0A:00)
# targetControllerDeviceNumber=00:0A:09 * (00:00:0E)
# Target candidates for source LDEV - 00:00:0E
# emulationType=OPEN-V
# CVS=Yes
# capacityInKB=10,240,320
# LBA=20,480,640
# subsystem=XP24000@172.16.110.1
# SLPRNumber=0
# CLPRNumber=0
# arrayGroupName=1-6-1
# diskType=-
# RAIDLevel=RAID5(3D+1P)
# cacheMode=Unknown
# IOSuppressionMode=Unknown
# xpThinProvisioning=-
# arrayGroupBusyRate=
# arrayGroupMaxBusyRate=
# targetControllerDeviceNumber=00:0A:02 * (00:0A:00)
# targetControllerDeviceNumber=00:0A:09 * (00:00:0E)
KATS10624-W message-contents
TIP:
If both of the conditions that some of the migration target volumes could not be found and some
of the migration target volumes are larger than their migration source volumes are satisfied, the
message KATS10602-W and the message KATS10624-W, which are the warning messages for
the respective conditions, are both output. In this case, the message KATS10624-W is output
before the message KATS10602-W.
• Command execution example (3):
This example uses the same conditions as those used for Command execution example (2) to
create a candidate migration plan. In this example, some of the migration target volumes cannot
be found.
htsmcli CreateMigrationPlan storagedomainname="MegaTechXP12000-Primary"
migrationgroupname="MG011" targetstoragetiername="MegaTech-HighCost"
• Execution results (3):
#Example plan for migration
plan-type=Migration
format-version=1.0
CLI Reference Guide 103