HP StorageWorks P9000 Tiered Storage Manager Software 7.1.1 CLI Reference Guide (TB585-96014, September 2011)

DescriptionItem
The name of the storage system that stores the actual data for the migration target
volume.
If the storage system name is unknown, the product name and serial number are
displayed.
targetSubsystem-
Name
The vendor name of the storage system that stores the actual data for the migration
target volume
targetSubsystem-
Vendor
The LDEV number of the LU in the storage system that stores the actual data of the
migration target volume.
The number is displayed as a decimal number or a value that is a combination of
hexadecimal values and colons (:).
targetSubsystem-
DeviceNumber
The device ID of the LU in the storage system that stores the actual data of the
migration target volume.
For the HP storage system, - is displayed.
targetSubsystem-
DeviceID
The number for the SLPR to which the migration target volume belongs
targetSLPRNumber
The number for the CLPR to which the migration target volume belongs
targetCLPRNumber
The RAID level of the migration target volume
targetRAIDLevel
The type of drives in which the migration target volume exists
targetDiskType
The name of the controller parity group in which the migration target volume exists
targetControllerAr-
rayGroupName
The parity group name of the migration target volume
targetArrayGroup-
Name
The parity group usage rate (%) of the target volume. Up to 2 decimal places are
displayed.
targetArrayGroup-
BusyRate
The maximum parity group usage rate (%) of the target volume. Up to 2 decimal
places are displayed.
targetArrayGroup-
MaxBusyRate
The emulation type
emulationType
The capacity of the volume (units: KB).
capacityInKB
The migration status for each volume
For details on the values displayed, see “Task statuses” on page 177.
status
Indicates the migration progress for each volume, as a percentage. Values of less
than 1% are rounded down and displayed as an integer. (For example, 45.3% is
rounded down to 45%.)
migrationProgress
The elapsed time from the start of the task execution for each volume.
This value is displayed in hhhh:mm:ss format.
If the elapsed time is 10,000 hours or more, 9999:59:59 is displayed. If the
elapsed time cannot be acquired, n/a is displayed. If the task is not executed,
nothing is displayed.
timeElapsed
CLI Reference Guide 127