HP StorageWorks P9000 Tiered Storage Manager Software 7.1.1 CLI Reference Guide (TB585-96014, September 2011)

htsmcli AddVolumeToMigrationGroup --detail
storagedomainname="MegaTechXP12000-Primary" name="MG011"
controllerdevicenumber="3:A6" movefrommigrationgroup=Yes
• Execution results:
RESPONSE:
An instance of StorageDomain(1 of 1)
name=MegaTechXP12000-Primary
List of 1 MigrationGroup elements:
An instance of MigrationGroup(1 of 1)
name=MG011
canMigrate=Yes
notifyToURL=
remindAt=
reminderDescription=
arrayGroupSelectionRule=MinimumCoverage
arrayGroupAvoidanceOfMigrationGroups=MG012,MG013
description=MigrationGroup011
List of 1 Volume elements:
An instance of Volume(1 of 1)
controllerDeviceNumber=3:A6
emulationType=OPEN-V
CVS=Yes
capacityInKB=10,240,320
RAIDLevel=RAID5(3D+1P)
diskType=Unknown
controllerArrayGroupName=E9980-1
arrayGroupName=1-9-1
volumeStatus=Used
volumeLockStatus=Unlocked
hostNames=
RemoveVolumeFromMigrationGroup
The RemoveVolumeFromMigrationGroup command can be used to remove a specified volume
from its migration group. Use the LDEV number in the domain controller (controller LDEV number) to
specify a volume.
Note that volumes cannot be removed from migration groups in the following statuses:
• Migration groups specified for tasks that have not ended (End)
• Migration groups within storage domains whose refresh status is either Processing or Failure
You can use the GetTasks command to check the status of tasks.
If this command is executed for a storage domain that requires a refresh, a warning message will be
output to the standard error output.
Details of CLI commands90