HP StorageWorks P9000 Tiered Storage Manager Software 7.1.1 CLI Reference Guide (TB585-96014, September 2011)

The value in KB is displayed in parentheses in addition to the value in TB, GB, MB, or KB. The
value is displayed to two decimal places for TB or GB and as an integer for MB or KB.
#2
When the emulation type is OPEN-V, the CVS attribute is not displayed. When the emulation
type is other than OPEN-V and the LDEV type is the CSV attribute, CVS is displayed. When the
emulation type is not OPEN-V and the LDEV type is not the CSV attribute, nonCVS is displayed.
Table 43 Items output by the CreateMigrationPlan command (information about each volume pair to
be migrated)
DescriptionItem
The symbol indicating the start of specification for a migration source volume and
migration target volume
pair
The LUSE attribute
[ LUSE ]
The LU device number
[ LU ]
The emulation type
[ emulationType ]
The CVS volume attribute of the volume
This can be either Yes or No.
[ CVS ]
The capacity of the volume (units: KB)
[ capacityInKB ]
The volume capacity in blocks
[ LBA ]
The SLPR number
[ SLPRNumber ]
The CLPR number
[ CLPRNumber ]
The cache mode
[ cacheMode ]
The IO suppression mode
[ IOSuppression-
Mode ]
The controller LDEV number of the migration source volume
The number is displayed as a value that is a combination of hexadecimal values
and colons (:).
sourceController-
DeviceNumber
The controller LDEV number of the migration target volume
The number is displayed as a value that is a combination of hexadecimal values
and colons (:). Nothing is displayed when a migration target volume cannot be
selected.
If the command cannot find some of the target volumes, the character string
NotMigrate is displayed.
targetController-
DeviceNumber
The target THP pool number
This item is automatically displayed when the migration target is a THP pool. (That
is when the storage tier created according to the pool filter conditions for the
targetstoragetiername parameter is specified.)
If you create a migration plan by specifying volume filter conditions, this line will
not be displayed.
If the migration target for the migration source volume cannot be set to a pool
volume, or if there is no pool volume that can be specified as a migration target,
nothing is output.
targetPoolId
CLI Reference Guide 97