HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 CLI Reference Guide

ManualsBrandsHP ManualsSoftwareHP XP P9000 Command View Advanced Edition Software

211

212

213

214

215

216

217

218

219

220

ModifyPool

ModifyPool expands a THP/Smart pool or changes the settings related to the THP/Smart pool.

NOTE:

• This command can be used only with P9500 and XP24000/XP20000.

• The attributes of the Pool instance, thresholdVolForewarn and thresholdVolOverwarn,

which were output as the execution results of this command, have changed to overProvision-

ingWarning and overProvisioningLimit, respectively. Check and, if necessary, revise

the script settings that you use in version 6.3 or later.

To expand a THP/Smart pool, the following conditions must be satisfied:

• The conditions on logical units to be specified as pool volumes, which are listed in “Ad-

dPool” on page 78.

• For P9500 and XP24000/XP20000, the status of the THP/Smart pool is not Blocked and the

usage rate is not 100%.

For P9500 and XP24000/XP20000, the following conditions must be satisfied if you want to change

the settings related to a THP/Smart pool:

• If the status of the THP/Smart pool is Normal, the usage rate is less than 95%.

• When changing the threshold value, you specify a value that is larger than the value set for the

usage rate of the THP/Smart pool at that time.

Format for P9500

When the command is used to expand a THP/Smart pool:

hdvmcli [URL] ModifyPool [options]

model=model serialnum=serial-number poolid=pool-ID

adddevnums=device-number-of-logical-unit

[threshold=THP/Smart-pool-threshold-1]

[threshold2=THP/Smart-pool-threshold-2] [threshold2mode={0|1}]

[overprovisioningwarning=over-provisioning-warning-threshold]

[overprovisioninglimit=over-provisioning-limit-threshold]

[tiercontrol={enable|disable}]

[automigration={enable|disable}] [migrationinterval={0|1|2|4|8|24}]

[monitorstarttime=start-time-of-performance-monitoring]

[monitorendtime=end-time-of-performance-monitoring]

[monitoringmode={0|1}]

When changing only the settings related to the THP/Smart pool: