HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 CLI Reference Guide

domain=domain-ID [scsi=SCSI-ID] lun=valid-LUN
{devnum=device-number|lusedevnums=list-of-LDEV-numbers}
NOTE:
When setting up a LUN (path) to an LU to which a LUSE is already set, like the following command,
you must specify devnum of the representative LDEV which constitutes the LUSE, and run AddLun.
hdvmcli AddLun serialnum=30117 model=XP128 name=vail11 port=3 domain=0
scsi=15 lun=10 devnum=263
Parameters
Table 85 AddLun command parameters
DescriptionStatusParameter name
Serial number of the new path's storage systemRequired
serialnum
Model of the new path's storage systemRequired
model
Name of the new path
You can use a character string of 1-64 bytes for a name.
Spaces at the beginning or end of a name are not registered.
Optional
name
Port number of the new path
Specify either port or portname. Do not specify both
parameters at the same time. If they are specified at the same
time, an error occurs.
Optional
port
Port name of the new path
Specify either port or portname. Do not specify both
parameters at the same time. If they are specified at the same
time, an error occurs.
Optional
portname
Domain ID of the new path
You cannot specify this parameter and the domainnickname
parameter at the same time. If they are specified at the same time,
an error occurs.
This parameter can be specified in decimal and hexadecimal. If
you specify a hexadecimal number, add the 0x prefix.
The execution results are output in decimal.
Optional
domain
Nickname of the host storage domain of the new path
You cannot specify this parameter and the domain parameter at
the same time. If they are specified at the same time, an error
occurs.
Optional
domainnickname
SCSI ID of the new path
For Fibre Channel, specify 15.
Optional
scsi
CLI Reference Guide 261