HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 CLI Reference Guide

DescriptionStatusParameter name
Comma-separated list of WWNs to secure the host storage domain
If you use the HostScan command to register a host in Device
Manager, every WWN that you specify in the wwn parameter
must be a WWN used by that host only. In this case, the value
specified for the domainnickname parameter is used as the
name of the host. For details about the HostScan command, see
“HostScan” on page 300.
Required
wwn
The nickname of the WWN
Specify this parameter to register the WWN nickname. To specify
two or more WWN nicknames, separate them with commas.
The number of wwn parameters must match the number of
wwnnickname parameters.
Paired wwn parameters and wwnnickname parameters must be
specified in the same sequence.
You can use the following characters:
A-Z a-z 0-9 ! # $ % & ' ( ) + - . = @ [ ] ^ _ ` { } ~ and
spaces
A WWN nickname cannot begin or end with spaces.
The character string used for a WWN nickname must be within
the following range:
• P9500: 1-64 bytes
• XP24000/XP20000: 1-32 bytes
• XP12000/XP10000/SVS200:
Microcode version earlier than 50-04-01: 1-16 bytes
Microcode version 50-04-01 or later: 1-32 bytes
• XP1024/XP128: 1-8 bytes
Optional
wwnnickname
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. In the execution
result, use the arrayType value or the displayArrayType value to specify the model para-
meter, and use the serialNumber value to specify the serialnum parameter.
port and domain
Obtain these values from the execution result of the GetStorageArray (subtarget=Host-
StorageDomain) command. Execute this command by specifying only the model and serial-
num parameters, and HostStorageDomain for the subtarget parameter. In the execution
result of this command, the portID and domainID values appear under An instance of
HostStorageDomain. Use these portID and domainID values to specify the port and do-
main parameters respectively.
portname
Obtain this value from the execution result of the GetStorageArray (subtarget=Port)
command. In the execution result of this command, the displayName value appears under An
instance of Port. Use this value to specify the portname parameter.
wwn
Obtain this value from the execution result of the GetStorageArray (subtarget=Port,
portsubinfo=WWN) command. Execute this command by specifying only the model and
CLI Reference Guide 267