HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 CLI Reference Guide

Parameters
Table 89 DeleteWWNForHostStorageDomain command parameters
DescriptionStatusParameter name
Serial number of the storage system for the host storage domainRequired
serialnum
Model of the storage system for the host storage domainRequired
model
Port ID of the host storage domain
Specify either port or portname. Do not specify both
parameters at the same time. If they are specified at the same
time, an error occurs.
Optional
port
Port name of the host storage domain
Specify either port or portname. Do not specify both
parameters at the same time. If they are specified at the same
time, an error occurs.
Optional
portname
Domain ID of the host storage domain
This parameter can be specified in decimal and hexadecimal. If
you specify a hexadecimal number, add the 0x prefix.
The execution results are output in decimal.
You must specify either domain or domainnickname. Do not
specify both parameters at the same time. If they are specified at
the same time, an error occurs.
Optional
domain
The nickname of the host storage domain
You must specify either domain or domainnickname. Do not
specify both parameters at the same time. If they are specified at
the same time, an error occurs.
Optional
domainnickname
Comma-separated list of WWNs to unsecure the host storage
domain
To specify two or more options, separate them with commas.
You must specify either wwn or wwnnickname. Do not specify
both parameters at the same time. If they are specified at the
same time, an error occurs.
Optional
wwn
The WWN nickname that is used to cancel security for the host
storage domain
To specify two or more WWN nicknames, separate them with
commas.
You must specify either wwn or wwnnickname. Do not specify
both parameters at the same time. If they are specified at the
same time, an error occurs.
Optional
wwnnickname
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. In the execution
result, use the arrayType value or the displayArrayType value to specify the model para-
meter, and use the serialNumber value to specify the serialnum parameter.
Command reference272