HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 CLI Reference Guide

DescriptionStatusParameter name
Fence level of the P-VOL
This parameter applies only when Continuous Access Synchronous
Software is being used. In other cases, the value specified for this
parameter is ignored.
You can specify the following values:
• Never: If you specify Never, a host write request to the P-
VOL will not be rejected even though the MCU was able to
change the status of a S-VOL pair into the suspend status.
• Data: If you specify Data, a host write request to the P-VOL
will be rejected when an update copy fails.
• Status: If you specify Status, a host write request to the
P-VOL will be rejected only when the MCU cannot change
the status of an S-VOL pair to the suspend status.
If you omit the parameter, Never is specified.
Optional
fencelevel
Copy pace (number of tracks copied at one time during initial
copy)
You can specify an integer from 1 to 15.
If you omit this parameter, 3 is specified.
If Snapshot or ContinuousAccessJournal is specified for
the replicationfunction parameter, this parameter is
ignored.
Optional
copytracksize
The following value can be specified only when
XP12000/XP10000/SVS200 is being used:
suspend: Creates a delta resync pair.
Optional
pairoption
Parameter values to obtain in advance
Parameter values to obtain in advance depend on how you will create a copy pair.
• When Method 1 is used:
See No. 1, No. 4, and No. 5 in the table below.
• When Method 2 is used:
See No. 2, No. 3, No. 4, No. 5, and No. 6 in the table below.
• When Method 3 is used:
CLI Reference Guide 343