HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 CLI Reference Guide

NOTE:
• This command is not available for XP1024/XP128.
• You cannot execute any operations for Fast Snap copy pairs defined in the HORCM configuration
file.
• For Fast Snap, you cannot use the Device Manager CLI to perform any operations for consistency
groups.
• To delete a specific copy pair from a copy group, you must specify pvolserialnum,
pvoldevnum, svolserialnum (or svolsequencenum), and svoldevnum. If you omit all
of these parameters, the system deletes all copy pairs in the specified copy group.
• For Fast Snap, take special note of the following:
You must specify the hostid or hostname parameter.
To delete a specific copy pair from a snapshot group, you must specify the pvolarraytype,
pvolserialnum, pvoldevnum, svolserialnum, svoldevnum, and snapshotgroupid
(or snapshotgroupname) parameters.
To delete all the copy pairs from a snapshot group, you must specify the pvolarraytype,
pvolserialnum, and snapshotgroupid (or snapshotgroupname) parameters.
Parameters
Table 116 DeleteReplication command parameters
DescriptionStatusParameter name
Number of the copy group
You do not need to specify this parameter for Fast Snap.
Optional
replication-
groupid
Model of the storage system that contains the P-VOL
You must specify this parameter for Fast Snap. You do not need
to specify this parameter for functions other than Fast Snap.
Optional
pvolarraytype
Serial number of the storage system that contains the primary
volume (P-VOL)
You must specify this parameter for Fast Snap.
Optional
pvolserialnum
Device number of the P-VOL
For P9500 and XP24000/XP20000:
Specify this parameter as a decimal number or colon-delim-
ited hexadecimal number in the format ww:xx:yy, where
ww is the LDKC number, xx is the CU number, and yy is the
LDEV number. ww is optional. If ww is omitted, LDKC is as-
sumed to be 0.
For XP12000/XP10000/SVS200:
Specify this parameter as a decimal number or colon-delim-
ited hexadecimal number in the format xx:yy, where xx is
the CU number, and yy is the LDEV number.
The execution results are output in decimal.
Optional
pvoldevnum
Command reference356