HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 CLI Reference Guide

DescriptionStatusParameter name
Specify one of the following values:
• split: Split the copy pair.
• resync: Re-synchronize the copy pair from the primary
volume (P-VOL) to the secondary volume (S-VOL).
• restore: Re-synchronize the copy pair from the S-VOL to the
P-VOL.
If you re-synchronize a Snapshot or Fast Snap copy pair, the copy
pair is split after the re-synchronization. For this reason, the paired
volume status is set to PAIR, and then changes toPSUS.
Required
operation
Model of the storage system that contains the P-VOL
You must specify this parameter for Fast Snap. You do not need
to specify this parameter for functions other than Fast Snap.
Optional
pvolarraytype
Serial number of the storage system that contains the P-VOL
You must specify this parameter for Fast Snap.
Optional
pvolserialnum
Device number of the P-VOL
For P9500 and XP24000/XP20000:
Specify this parameter as a decimal number or colon-delim-
ited hexadecimal number in the format ww:xx:yy, where
ww is the LDKC number, xx is the CU number, and yy is the
LDEV number. ww is optional. If ww is omitted, LDKC is as-
sumed to be 0.
For XP12000/XP10000/SVS200 and XP1024/XP128:
Specify this parameter as a decimal number or colon-delim-
ited hexadecimal number in the format xx:yy, where xx is
the CU number, and yy is the LDEV number.
The execution results are output in decimal.
Optional
pvoldevnum
Serial number of the storage system that contains the S-VOL
If you specify this parameter, do not specify the
svolsequencenum parameter. If they are specified at the same
time, an error occurs.
Optional
svolserialnum
Sequence number of the storage system that contains the S-VOL
If you specify this parameter, do not specify the svolserialnum
parameter. If they are specified at the same time, an error occurs.
Optional
svolsequen-
cenum
Device number of the S-VOL
For P9500 and XP24000/XP20000:
Specify this parameter as a decimal number or colon-delim-
ited hexadecimal number in the format ww:xx:yy, where
ww is the LDKC number, xx is the CU number, and yy is the
LDEV number. ww is optional. If ww is omitted, LDKC is as-
sumed to be 0.
For XP12000/XP10000/SVS200 and XP1024/XP128:
Specify this parameter as a decimal number or colon-delim-
ited hexadecimal number in the format xx:yy, where xx is
the CU number, and yy is the LDEV number.
The execution results are output in decimal.
Optional
svoldevnum
CLI Reference Guide 365