HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 CLI Reference Guide

DescriptionStatusParameter name
LU creation method
Specify a creation method for creating multiple LUs at once.
One of the following values can be specified:
• bulk: Creates LUs by specifying their capacity and number.
If you specify bulk, also specify capacity and numoflus.
• dividebynum: Creates LUs by specifying their number.
If you specify dividebynum, also specify numoflus but do
not specify capacity.
• dividebycap: Creates LUs by specifying their capacity.
If you specify dividebycap, also specify capacity but do
not specify numoflus.
If you omit this parameter, also specify capacity but do not
specify fsindex or numoflus.
Optional
(P9500
XP24000
XP20000
XP12000
XP10000
SVS200)
creationop-
tion
#
Capacity of the LUs to be created
This parameter must be specified if the creationoption
parameter is not specified, or if bulk or dividebycap is
specified for the creationoption parameter.
This parameter cannot be specified if dividebynum is specified
for the creationoption parameter.
The specified value is adjusted depending on the minimum number
of units set for the volume size of each storage system. Therefore,
the size of the logical unit that was actually created might exceed
the specified value.
You can use the capacitytype parameter to specify the unit
used for capacity (KB or blocks).
Optional
capacity
Number of LUs to be created
This parameter must be specified if bulk or dividebynum is
specified for the creationoption parameter.
Do not specify this parameter if the creationoption parameter
is not specified, or dividebycap is specified for the
creationoption parameter.
Optional
(P9500
XP24000
XP20000
XP12000
XP10000
SVS200)
numoflus
CLI Reference Guide 71