HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 CLI Reference Guide

Parameters
Table 28 AddStorageArray command parameters
DescriptionStatusParameter name
IP address
For P9500, XP24000/XP20000, XP12000/XP10000/SVS200,
and XP1024/XP128:
Specify the IP address of the storage system. You can also
specify the host name (alias name) of the port controller of
the storage system.
For P9500 and XP24000/XP20000, this parameter can be
specified by using an IPv6 IP address.
For an SMI-S enabled storage system:
Specify the IP address of the SMI-S provider.
You can also specify the IPv6 address or host name (alias
name).
Required
ipaddress
Family of the storage systemRequired
family
Display name of the storage system family
You cannot omit this parameter when using the command to
perform initial registration of information.
Required or option-
al
displayfamily
User ID
For P9500, XP24000/XP20000, XP12000/XP10000/SVS200,
and XP1024/XP128:
Specify the user ID used to access the storage system.
You cannot omit this parameter when using the command to
perform initial registration of information. However, you can
omit this parameter when updating information, if you do
not change the user ID.
For an SMI-S enabled storage system:
Specify the user ID used to access the SMI-S provider.
You cannot omit this parameter when using the command to
perform initial registration of information. However, you can
omit this parameter when using the command to refresh the
information about the storage system.
Required or option-
al
userid
#
User password
For P9500, XP24000/XP20000, XP12000/XP10000/SVS200,
and XP1024/XP128:
Specify the user password used to access the storage system.
You cannot omit this parameter when using the command to
perform initial registration of information. However, you can
omit this parameter when updating information, if you do
not change the user password.
For an SMI-S enabled storage system:
Specify the user password used to access the SMI-S provider.
You cannot omit this parameter when using the command to
perform initial registration of information. However, you can
omit this parameter when using the command to refresh the
information about the storage system.
Required or option-
al
arraypasswd
#
Command reference90