HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 CLI Reference Guide

3. Check the execution status of performance monitoring.
Execute the GetTieredPoolStatus command to check the execution results.
Check the values of monitoringState, lastMonitorStartDate, and
lastMonitorEndDate under An instance of Pool displayed in the execution results. For
details about the values, see Table 145.
4. Start hardware tier relocation.
Execute the AddTieredPoolOperation command with startRelocation specified for the
operation parameter.
Hardware tier are relocated based on the performance monitoring information obtained from
the time step 1 is executed until the time step 2 is executed.
5. Check the execution status of hardware tier relocation.
Execute the GetTieredPoolStatus command to check the execution results.
Check the values of relocationState and relocationProgress displayed in the execution
results. For details about the values, see Table 145.
Table 29 AddTieredPoolOperation command parameters
DescriptionStatusParameter name
Serial number of the storage systemRequired
serialnum
Model of the storage systemRequired
model
Specify one of the following values:
• startMonitor: Starts performance monitoring.
• stopMonitor: Stops performance monitoring.
• startRelocation: Starts hardware tier relocation.
• stopRelocation: Stops hardware tier relocation.
Specify stopRelocation when suspending hardware tier
relocation performed by using the AddTieredPoolOperation
command.
Required
operation
List of pool IDs
Specify the pool ID of a Smart pool.
Use a comma to delimit multiple values.
The maximum number of pool IDs that can be specified is 128.
Required
poolids
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. In the execution
result, use the arrayType value or the displayArrayType value to specify the model para-
meter, and use the serialNumber value to specify the serialnum parameter.
poolids
Obtain this value from the execution result of the GetStorageArray (subtarget=Pool)
command. When you execute this command, specify values that have been obtained in advance
for the serialnum and model parameters, and then specify 5 (Thin Provisioning) for the
poolfilter parameter. In the execution results of this command, the values of poolID and
Command reference94