HP XP P9000 Replication Manager Software 7.6.0-00 User Guide

Output
The information output by the GetTasks command is as follows:
• Task ID
• MF/Open
• Host (Primary/Secondary). (A hyphen is displayed for the Host (Primary) information when a copy
group is defined as a device group.)
• Target
• Copy Type
• TaskType
• Status
• Creation Time
• Execution Start Time
• Execution End Time
• Message
• Detail Message
Executing a task (ExecuteTask)
The ExecuteTasks command executes a task that was created for execution by the Replication
Manager CLI. When you run the ExecuteTask command, you must specify parameters for user
authentication.
Syntax
ExecuteTask {-u | --user} user-id {-p | --password} password taskID=task-id
Parameters
Each of the following parameters is required.
DescriptionParameter
Specify a user id that is used to log in to the management server. The spe-
cified user must have the Admin or Modify authority of Replication Manager,
and must belong to the All Resources group.
-u user-id
or
--user user-id
Specifies the password associated with the user ID.
-p password
or
-- password password
Specifies the ID of a CLI task. You can only specify a single taskID.taskID
Return values
DescriptionValue
Normal termination0
An error occurred1
User Guide 451