HP StorageWorks P9000 Performance Advisor Software v5.2 Command-line User Interface Reference Guide (T1789-96316, May 2011)

NOTE:
The port type, such as Fibre, Ficon, Escon, or FCoE (applicable only for P9000 disk arrays) is also
displayed beside the CHIP port ID. The CHIP Port Status in the LUNH output displays the port type.
If an array is connected to a host agent that is running the HP-UX 11i v3 operating system, the device
special file (DSF) is displayed in a new format. A legacy DSF is displayed in parenthesis next to the
new format.
Cache Fast Writes and Direct Access Storage Device (DASD) Fast Writes are applicable to mainframe
volumes only.
For an XP24000 array with P9000 Thin Provisioning and P9000 Snapshot under RAID Group, the
following output is displayed:
• For P9000 Thin Provisioning:
THP-PID<pool ID>
• For P9000 Snapshot:
SNAP-PID<pool ID>.
Switches
Required. Specifies the host ID for which LUN information is reported.
The word "all" can be used to indicate all hosts.
—ha <host ID>
Specifies the host system name.–ha <host name>
Specifies the delimiter for the delimited output.
There is no space between -d and the delimiter.
–d<delim>
Specifies the labeled and the delimited output data.–L
Displays data in a human readable format.–hr
Specify the array serial number. The word "all" can be used to indicate all DKCs.–dkc <serial #>
Specifies the address of a management station in the format <http://
path.to.managementstation:<port>> or <https://path.to.manage-
mentstation>.
–ms <URL>
Specify a user name and password pair in the format user name:password.–auth <user:passwd>
Specifies the version number.
Indicates how the data must be displayed.
Currently, the supported values are 010500, 010600, and 015100.
The default value is 010500.
–dver <xxxxxx>
Specifies the maximum number of records to view.
You cannot specify a number of records higher than 16000.
–mr <maxRecords>
Specifies the RAID Group for which you want the output displayed.
The word "all" may be used here to indicate all hosts.
Not adding this switch has the same effect.
–rg <raidGroup>
HP StorageWorks P9000 Performance Advisor Software Command-Line User Interface Reference
Guide 21