HP StorageWorks P9000 Performance Advisor Software v5.2 Command-line User Interface Reference Guide (T1789-96316, May 2011)

NOTE:
The port type, such as Fibre, Ficon, Escon, or FCoE (applicable only for P9000 disk arrays) is also
displayed beside the CHIP port ID. The CHIP Port Status in the LUND output displays the port type.
If an array is connected to a host agent that is running the HP-UX 11i v3 operating system, the DSF
(device special file) is displayed in a new format. A legacy DSF is displayed in parenthesis next to
the new format.
Cache Fast Writes and DASD Fast Writes are applicable for mainframe volumes only.
For an XP24000 array with P9000 Thin Provisioning and P9000 Snapshot, the output displayed,
under RAID Group, for P9000 Thin Provisioning is THP-PID<pool ID> and the output for Snapshot
is SNAP-PID<pool ID>.
For an XP24000 array with P9000 Thin Provisioning and P9000 Snapshot under RAID Group, the
following output is displayed:
• For P9000 Thin Provisioning:
THP-PID<pool ID>
• For P9000 Snapshot:
SNAP-PID<pool ID>.
Switches
Required. Specify the array serial number. The word "all" can be used to indicate
all DKCs.
–dkc <serial #>
Specify the delimiter for delimited output. There is no space between -d and the
delimiter.
–d<delim>
Specify the labeled and delimited output data.–L
Displays data in a readable format.–hr
Specify the host ID for which LUN information is displayed. The word "all" can be
used to indicate all hosts.
–ha <host ID>
Specify the address of a management station in the format <http://
path.to.managementstation:<port>> or <https://path.to.manage-
mentstation>.
–ms <URL>
Specify a user name and password pair in the format user name:password.–auth <user:passwd>
Specify the version number. Indicates how the data must be displayed. Currently
supported values are 010500, 010600, and 015100. The default value is
010500.
–dver <xxxxxx>
Specify the maximum number of records to return. You cannot specify a number
of records higher than 16000.
–mr <maxRecords>
Specify the RAID Group for which you want the output displayed.
The word "all" can be used to indicate all hosts. Not adding this switch has the
same effect.
–rg <raidGroup>
HP StorageWorks P9000 Performance Advisor Software Command-Line User Interface Reference
Guide 23