HP StorageWorks P9000 Performance Advisor Software v5.2 Command-line User Interface Reference Guide (T1789-96316, May 2011)

Required Specify the alarm metric to watch. Not required if -list is used. Valid values
are:
nl
IO_TOTAL LDEV IO Total
nl
IO_RAND_TOTAL LDEV IO Random Total
nl
IO_RAND_READ LDEV IO Random Read
nl
IO_RAND_READ_CACHE LDEV IO Random Read Cache Hits
nl
IO_RAND_WRITE LDEV IO Random Write
nl
IO_RAND_WRITE_CACHE LDEV IO Random Write Cache Hits
nl
IO_SEQ_TOTAL LDEV IO Sequential Total
nl
IO_SEQ_READ LDEV IO Sequential Read
nl
IO_SEQ_READ_CACHE LDEV IO Sequential Read Cache Hits
nl
IO_SEQ_WRITE LDEV IO Sequential Write
nl
IO_SEQ_WRITE_CACHE LDEV IO Sequential Write Cache Hits
nl
MB_TOTAL LDEV MB Total
nl
MB_RAND_TOTAL LDEV MB Random Total
nl
MB_RAND_READ LDEV MB Random Read
nl
MB_RAND_WRITE LDEV MB Random Write
nl
MB_SEQ_TOTAL LDEV MB Sequential Total
nl
MB_SEQ_READ LDEV MB Sequential Read
nl
MB_SEQ_WRITE LDEV MB Sequential Write
nl
CFW_TOTAL LDEV IO type
nl
CFW_READ LDEV IO type
nl
CFW_READ_CACHE LDEV IO type
nl
CFW_WRITE LDEV IO type
nl
CFW_WRITE_CACHE LDEV IO type
nl
DFW_COUNT LDEV IO type
nl
DFW_NRML_COUNT LDEV IO type
nl
DFW_SEQ_ACCESS LDEV IO type
nl
DFW_WRITE_HITS LDEV IO type
nl
DFW_SA_WRITE_HITS LDEV IO type
nl
CACHEMODE_INHIBIT LDEV IO type
nl
CACHEMODE_BYPASS LDEV IO type
nl
PORT_IO_MAX Port Maximum IO/s
nl
PORT_IO_MIN Port Minimum IO/s
nl
PORT_IO_AVE Port Average IO/s
nl
PORT_MB_MAX Port Maximum MB/s
nl
PORT_MB_MIN Port Minimum MB/s
nl
PORT_MB_AVE Port Average MB/s
nl
FBUS_HI DKC Bus Utilization
nl
FBUS_LO DKC Bus Utilization
nl
MBUS_HI DKC Bus Utilization
nl
MBUS_LO DKC Bus Utilization
nl
BACKEND_SEQ_READ LDEV Backend
nl
BACKEND_NONSEQ_READ LDEV Backend
nl
BACKEND_WRITE LDEV Backend
nl
THP_POOL_OCCUPANCY
nl
SNAPSHOT_POOL_OCCUPANCY
–metric <Metric
Category>
Indicates that the command must list only configured alarms.–list
Specify the address of a management station in the format <http://path.to.man-
agementstation:<port>> or <https://path.to.managementstation>.
–ms <management
station>
Specify a user name and password pair in the format user name:password.
–auth <user:pass-
wd>
HP StorageWorks P9000 Performance Advisor Software Command-Line User Interface Reference
Guide 31