HP StorageWorks P9000 Performance Advisor Software v5.4 Troubleshooting and FAQs Guide (T1789-96336, April 2012)

The message is of type SNMPv1. It has the following formant and content:
PDU version -- 0 (indicates type SNMPv1)
Community -- public
Message type -- 0xa4 (indicates a trap message)
Enterprise -- The vendor identification (OID).
Agent-Address -- The IP address of the management station where the trap is generated.
Generic Trap Type -- 6 (enterprise-specific)
Timestamp -- 0 (not used)
Variable bindings -- This field consists of a sequence of (oid/name=value) pairs. The content is the
same as the message that is sent by e-mail.
Following is the list of OIDs:
.1.3.6.1.4.1.11.2.27.5.1.1 (Server Name)
.1.3.6.1.4.1.11.2.27.5.1.2 (Sequence Number)
.1.3.6.1.4.1.11.2.27.5.1.3 (Source Application)
.1.3.6.1.4.1.11.2.27.5.1.4 (Alarm Type)
.1.3.6.1.4.1.11.2.27.5.1.5 (Minor Type)
.1.3.6.1.4.1.11.2.27.5.1.6 (Metric Value)
.1.3.6.1.4.1.11.2.27.5.1.7 (DKC Serial Number)
.1.3.6.1.4.1.11.2.27.5.1.8 (DKC Type)
.1.3.6.1.4.1.11.2.27.5.1.9 (Level of the Detection)
.1.3.6.1.4.1.11.2.27.5.1.10 (Actual Value)
.1.3.6.1.4.1.11.2.27.5.1.11 (Threshold)
.1.3.6.1.4.1.11.2.27.5.1.12 (Time Stamp)
Discus-
sion
Table 11 Configuring the host agent: ManagementStation.Hostname
On Windows platforms:
C:\Program Files\Hewlett-Packard\xppa\
hostagent\config\paxp_service.properties
If installed in a different location, the path is as follows:
<Installation drive>:\xppa\hostagent\config\
paxp_service.properties.
On UNIX platforms:
/opt/xppa/hostagent/config/
paxp_service.properties
Common for both Windows and UNIX platforms:
C:\Program Files\Hewlett- Packard\xppa\
hostagent\config\xpmgmtstationaddress.prp.
File
These parameters are read when the host agent is started.
The host normally executes as a service under Microsoft
Windows or as a daemon under UNIX.
When Read
Frequently Asked Questions92