HP XP P9000 Performance Advisor Software v6.0 Command-line User Interface Reference Guide

CTG —Displays the CT group ID for the journal group
nl
JNLS —Displays the following status in the journal group
Primary Journal:
Constant valueStatus valueString
0Journal pool is not used in a journal group.JSTAT_SMPL
1This means P(S)vol Journal is Normal Normal.JSTAT_PJNN
2This means P(S)vol Journal is Suspend Normal.JSTAT_PJSN
3This means P(S)vol Journal is Normal Full.JSTAT_PJNF
4This means P(S)vol Journal is Suspend Full.JSTAT_PJSF
5This means P(S)vol Journal is Suspend Error including link failure.JSTAT_PJSE
Secondary Journal:
Constant valueStatus valueString
17This means S(S)vol Journal is Normal NormalJSTAT_SJNN
18This means S(S)vol Journal is Suspend Normal.JSTAT_SJNF
19This means S(S)vol Journal is Normal Full.JSTAT_SJSN
20This means S(S)vol Journal is Suspend Full.JSTAT_SJSF
21This means S(S)vol Journal is Suspend Error including Link failure.JSTAT_SJSE
Displays the actual number of paths.AP
Displays the usage rate of the journal pool in percentage format.U(%)
Displays the sequence number for the journal group ID, called the Q-marker.Q-Marker
Displays the number of remaining Q-Markers within each journal volume.Q-CNT
Displays the number of volumes configured for the journal group.Num
Displays the ID of the volume configured for the journal group.LDEV#
Displays the average read response time of the volume configured for the journal group.Avg Read
Displays the maximum read response time of the volume configured for the journal group.Max Read
N/AAvg Write
N/AMax Write
NOTE: Average and Maximum write metrics are not supported for the continuous access journal
pool LDEVs.
Switches
Required: Specify the array serial number.—dkc <serial #>
Specify the journal ID.–jid <journal pool id>
The journal LDEV's read and write response time.–resp
Specify the start time in the format mm.dd.yyyy hh:mm:ss.–st <mm.dd.yyyy
hh:mm:ss>
JNL 41