HP XP P9000 Performance Advisor Software v6.0 User Guide

Table 11 Smart Pool monitoring information table
DescriptionLabel name
Displays last available monitoring cycle start time with
PADB.
Last available start time
Displays last available monitoring cycle end time with
PADB.
Last available end time
Displays type of tier relocation. For example, Auto or
Manual.
Relocation Type
Displays mode of monitoring. For example, Period or
Continuous.
Monitoring Mode
Displays status of a monitoring cycle. For example,
Monitoring or Stop. If No-Status is displayed, then issue
outband configuration collection to get the current status.
Monitoring Status
Displays the duration of a monitoring cycle.Frequency
NOTE:
• While upgrading from v5.4 to v6.0 , the last monitoring cycle start and end time details are
not displayed. When performance collection resumes prior an upgrade, this value is displayed
below the pool information table.
• The user must perform configuration collection to view any change in Pool configuration data
like monitoring mode, relocation type, and monitoring status.
Viewing configuration and performance data for Smart pools and ThP pools
The Pool Information table displays the following configuration and performance data for all the
Smart pools and the ThP pools configured in the selected P9000 disk array.
Table 12 Pool Information table
DescriptionColumn names
Displays the Smart pool and the ThP pool IDs.Pool ID
Displays the pool type as either Smart or ThP for the pool ID.Pool Type
Displays the current status of the Smart pool or the ThP pool.
Following are the statuses and their descriptions:
Pool Status
• Normal: Indicates that the Smart or the ThP pool is functioning
properly.
• Over threshold: Indicates that the Smart or the ThP pool has
crossed the threshold capacity that you set on the P9000
disk array.
• Blocked: Indicates that the Smart or the ThP pool has reached
100% utilization and has gone into the suspended state.
There is no more storage space left.
• Failure: Indicates that the Smart or the ThP pool is in a failed
state.
The VVols performance data, the respective RAID groups,
and the pool LDEVs utilization data is not displayed for such
pools.
Displays the sum of the random and sequential read and write
I/Os on the individual Smart pool or the ThP pool.
IOPS
Displays the sum of the random and sequential reads and writes
in MB/s on the individual Smart pool or a ThP pool.
MBPS
196 Viewing XP and P9000 disk array components