HP XP P9000Watch and HP XP P9000Sketch Reference Guide for HP XP P9000 Performance Advisor v5.5 (T1789-96341, February 2013)

The Sync/Async Metrics provides configuration information for each P-VOL and S-VOL which
includes data displayed in the following table:
DescriptionScreen field
Selection Number.Num
S against a P-VOL or S-VOL record indicates that the
particular record is selected.
Sel
Serial number of the XP or P9000 disk array.Pri Ser#
LDEV configured as P-VOL or S-VOL on the selected disk
array (primary data center). Displays the LDEV number in
cu:ldev format.
Ldev
Type of the LDEV, can be P-VOL or S-VOL.Type
CLPR that manages cache for the P-VOL or S-VOL.CLPR
RAID group to which the P-VOL or S-VOL belongs.Rg
RAID classification for the RAID group.RAID
RAID type for the RAID group.Type
Size of the LDEV in MB.Ld[MB]
Current replication link status of the P-VOL or S-VOL on the
selected XP or P9000 disk array. The replication link status
State
shown is corresponding to only the selected XP or P9000
disk array and can be one of the following:
• SMPL: Unpaired volume
• PAIR: Paired duplicate volume
• COPY: In paired state but copying to secondary volume
not complete
• PSUS: In paired state but updating the secondary volume
data is suspended
• PSUE: PSUS state due to internal error
• PFUS: PSUS state due to Side File Full
Mirror Unit Number of the paired volume.MUN
Consistency Group ID: A Group ID which guarantees
consistency in the sequence of asynchronous data transfers
for a remote copy volume group.
CTG
Journal ID of the journal group associated with the P-VOL
or S-VOL.
JID
Fence level of target device (Pair volume). ASYNC for
asynchronous communications and DATA, STATE, or
NEVER for synchronous communications.
Fence
Number of active paths for a P-VOL, the continuous access
links (P-VOL to S-VOL). When continuous access is
Paths
configured as Sync or Async and the selected volume type
is SVOL, then you might encounter the status of the number
of paths as NA - Not Applicable.
Secondary data center disk array serial number on which
the S-VOL resides.
Sec Ser#
LDEV configured as S-VOL on the secondary data center
disk array. Displays the LDEV number in cu:ldev format.
Ldev
22 Working with HP XP P9000Watch menus and commands