XPWatch and XPSketch Reference guide for HP XP P9000 Performance Advisor

ManualsBrandsHP ManualsSoftwareHP XP P9000 Performance Advisor Software

This parameter is used to specify the number of hours for

which HP XP P9000Watch must be active.

—hrs

This parameter is used to specify the number of minutes

for which HP XP P9000Watch must be active.

—min

NOTE: It is mandatory to specify either the —hrs or —min option. You can also specify both the

options.

./xpwatch –c –s <array -serial number> –l <all|ldev-list> –p <all|port-list> –r <all|rg-list> [–f

<filename>] [–a <frequency for archiving data>] -hrs <number of hours for execution> —min

To view the HP XP P9000Watch in CLI mode.—c

To specify the XP or P9000 disk array serial number.—s

To view the list of LDEVs that must be given in a comma

separated format. If 'all' is specified in the parameter, it

will consider all the LDEVs for that particular disk array.

NOTE: There should be no space in between the comma

separating the LDEVs.

For example, –l 02:00,02:01

—l

To view the list of ports that must be given in a comma

separated format. If “all” is specified in the parameter, it

will consider all the ports for that particular disk array.

NOTE: There should be no space in between the comma

separating the ports.

For example, –p 1a,2a

—p

To view the list of RAID groups that must be given in a

comma separated format. If “all” is specified in the

—r

parameter, it will consider all the RAID groups for that

particular disk array.

NOTE: There should be no space in between the comma

separating the RAID groups.

For example, –r 01–10,10–01

This is an optional parameter. It is used to specify the .csv

filename. If this option is not specified, the archive file

(.csv file) will not be created.

—f

This is an optional parameter. It is used to specify the

frequency of archiving data in the .csv file. If this option

—a

is not specified then the previously specified value shall be

used. For more information, see Table 11 (page 37).

This parameter is used to specify the number of hours for

which HP XP P9000Watch must be active.

—hrs

This parameter is used to specify the number of minutes

for which HP XP P9000Watch must be active.

—min

NOTE: It is mandatory to use the options —l, —p, and —r together.

It is mandatory to specify either the —hrs or —min option. You can also specify both the options.

Commands 19