HP XP7 Continuous Access Synchronous User Guide (TK911-96004)

DescriptionError code
(SSB2)
The P-VOL is in the process of drive copy for failure assistance.C316
The P-VOL is in the process of drive copy for an SVP request.C317
The P-VOL is terminating the copy task.C318
The P-VOL is in the process of collection copy.C319
The P-VOL is in the process of collection access.C31A
The P-VOL is blocked.C31B
The P-VOL is blocked and impossible to access.C31C
The P-VOL is being formatted.C31D
The P-VOL is read only.C31E
The number of remote paths is 0 (not specified).C320
The number of remote paths is smaller than the minimum required.C321
The DKC type of the primary system does not support Cnt Ac-S.C322
The secondary system's sequence number, SSID, or CU are invalid.C324
The pair cannot be created because the P-VOL is not available for remote copy.C327
The track formats of the P-VOL and the S-VOL do not match.C328
The S-VOL is protected by the Data Retention.C32A
The P-VOL is protected by the Data Retention.C32B
The S-VOL is protected by the Data Retention.C32C
The S-VOL is protected by the Data Retention.C32D
A request for a Paircreate operation was rejected because the specified secondary system is an unsupported
product.
C32E
The number of P-VOL cylinders is not the same or smaller than the number of S-VOL cylinders.)C32F
The pair cannot be created or resynchronized because P-VOL and S-VOL capacities are not the same, or
because the S-VOL is in a LUSE configuration.
C330
S-VOL cache is unavailable.C332
S-VOL DFW is disabled.C333
The S-VOL is the Cnt Ac-S P-VOL.C335
The S-VOL includes PIN data.C336
The S-VOL is in reserve status.C337
Copy pair cannot be created because of the either of the following reasons.C338
• The S-VOL is in the intervention-required condition, protected, or unusable status.
• The S-VOL is the S-VOL or Reserved volume of Business Copy, Reserved volume of Auto LUN, or the
volume of Cnt Ac-J pair.
The S-VOL is not available.C339
A request for a Paircreate operation was rejected because the secondary system is a not supported by Cnt
Ac-S.
C33A
The corresponding volume cannot be specified as an S-VOL because the volume is used as another pair's
S-VOL.
C33B
86 Troubleshooting