HP P9000 Command View Advanced Edition Suite Software 7.2 CLI Reference Guide

Format
When obtaining information about all storage systems:
hdvmcli [URL] GetStorageArray [options] subtarget=CommParameters
When obtaining information about a storage system (other than an SMI-S Enabled storage system):
hdvmcli [URL] GetStorageArray [options] subtarget=CommParameters
serialnum=serial-number model=model
When obtaining information about an SMI-S Enabled storage system:
hdvmcli [URL] GetStorageArray [options] subtarget=CommParameters
saobjid=object-ID-of-SMI-S-Enabled-storage-system
Parameters
Table 47 GetStorageArray (subtarget=CommParameters) command parameters
DescriptionStatusParameter name
Specify CommParameters.
Required
subtarget
Serial number of the storage system
You cannot specify this parameter if you are obtaining information
about a particular SMI-S Enabled storage system.
Optional
#
serialnum
Model of the storage system
You cannot specify this parameter if you are obtaining information
about a particular SMI-S Enabled storage system.
Optional
#
model
Object ID of the SMI-S Enabled storage system
Specify the object ID obtained from another CLI response. The
value is encoded by the CLI.
Optional
#
saobjid
#
Do not set saobjid together with serialnum and model. Doing so will result in an error.
Omitting all three parameters will cause all of the storage systems to be targeted.
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. In the execution
result, use the arrayType value or the displayArrayType value to specify the model para-
meter, and use the serialNumber value to specify the serialnum parameter.
saobjid
Obtain this value from the execution result of the GetStorageArray command. Set the value
of objectID, obtained from the execution result, into the saobjid parameter.
Command reference124