HP P9000 Command View Advanced Edition Suite Software 7.2 CLI Reference Guide

Parameters
Table 60 GetStorageArray (subtarget=Port) command parameters
DescriptionStatusParameter name
Specify Port.
Required
subtarget
Serial number of the storage system
If you omit this parameter, all the storage systems become the
target.
Optional
serialnum
Model of the storage system
If you omit this parameter, all the storage systems become the
target.
Optional
model
Number of the port of the storage system
Specify this parameter when you want to obtain information about
a specific port. If port and portname are omitted, information
about all ports is displayed. If you specify this parameter, you
must also specify the model and serialnum parameters.
Do not specify port and portname at the same time. If they are
specified at the same time, an error will occur.
Optional
port
Port name for the storage system
Specify this parameter when you want to obtain information about
a specific port. If port and portname are omitted, information
about all ports is displayed. If you specify this parameter, you
must also specify the model and serialnum parameters.
Do not specify port and portname at the same time. If they are
specified at the same time, an error will occur.
Optional
portname
Specific information about the ports
The values you can specify are HostStorageDomain and WWN.
If you specify multiple values at the same time, separate the values
by commas.
Optional
portsubinfo
Type of port about which you want to obtain information
The values you can specify are LCP, Fibre, SCSI, FICON, NAS,
and ISCSI, and FCoE.
If you specify multiple values at the same time, separate the values
by semicolons (;).
Optional
portfilter
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. In the execution
result, use the arrayType value or the displayArrayType value to specify the model para-
meter, and use the serialNumber value to specify the serialnum parameter.
port
Obtain this value from the execution result of the GetStorageArray (subtarget=Port)
command. Execute this command by specifying only the model and serialnum parameters,
and the value for subtarget=Port. In the execution result of this command, the required
Command reference166