HP P9000 Command View Advanced Edition Suite Software 7.2 CLI Reference Guide

DescriptionStatusParameter name
Specify this parameter when you change the type of the THP pool.
One of the following values can be specified.
• enable: Changes the pool to a pool for Smart Tiers.
• disable: Changes the pool to a pool for Thin Provisioning
Software.
Optional
(P9500)
tiercontrol
#1,
#5
Specify whether to automatically execute performance monitoring
and hardware tier relocation.
If you specify this parameter, you must also specify
tiercontrol=enable.
This parameter can be specified when tiercontrol is set to
enable.
One of the following values can be specified.
• enable: Performs automatic execution.
• disable: Does not perform automatic execution.
Optional
(P9500)
automigra-
tion
#1, #5
Execution cycle of performance monitoring and hardware tier
relocation
This parameter can be specified when automigration is set
to enable.
One of the following values can be specified.
• 0: 30 minutes
• 1: 1 hour
• 2: 2 hours
• 4: 4 hours
• 8: 8 hours
• 24: 24 hours
You can specify 0 only when the microcode version is
70-02-XX-XX/XX or later.
Optional
(P9500)
migrationinter-
val
#1, #5
Start time of performance monitoring
This parameter can be specified when migrationinterval
is set to 24.
Specify a time in the range from 00:00 to 23:59 in HH:MM
format.
Optional
(P9500)
monitorstart-
time
#1, #5, #6
End time of performance monitoring
This parameter can be specified when migrationinterval
is set to 24.
Specify a time in the range from 00:00 to 23:59 in HH:MM
format.
Optional
(P9500)
monitorend-
time
#1, #5, #6
Command reference186