HP P9000 Command View Advanced Edition Suite Software 7.2 CLI Reference Guide

DescriptionStatusParameter name
Type of operation that is to be executed with the copy pair
You can specify the following values:
• BusinessCopy: Business Copy Software
• ContinuousAccessSync: Continuous Access Synchronous
Software
• ContinuousAccessAsync: Continuous Access Asynchron-
ous Software
• Snapshot: Snapshot
• ContinuousAccessJournal: Continuous Access Journal
Software
Required
replication-
function
MU number of the P-VOL
This parameter can be specified only for Continuous Access
Journal Software.
If this parameter is not specified, Device Manager automatically
specifies the value.
Optional
munum
Fence level of the P-VOL
The fence level is ignored for Business Copy Software, Continuous
Access Asynchronous Software, Snapshot, and Continuous Access
Journal Software.
You can specify the following values:
• Never: If you specify Never, a host write request to the P-
VOL will not be rejected even though the MCU was able to
change the status of a S-VOL pair into the suspend status.
• Data: If you specify Data, a host write request to the P-VOL
will be rejected when an update copy fails.
• Status: If you specify Status, a host write request to the
P-VOL will be rejected only when the MCU cannot change
the status of an S-VOL pair to the suspend status.
If you omit the parameter, Never is specified.
Optional
fencelevel
Copy pace (number of tracks copied at one time during initial
copy)
You can specify an integer from 1 to 15.
If you omit this parameter, 3 is specified.
If Snapshot or ContinuousAccessJournal is specified for
the replicationfunction parameter, this parameter will be
ignored.
Optional
copytracksize
The following value can be specified only when
XP12000/XP10000/SVS200 is being used:
suspend: Creates a delta resync pair.
Optional
pairoption
Parameter values to obtain in advance
Parameter values to obtain in advance depend on how you will create a copy pair.
• When Method 1 is used:
See No. 1, No. 4, and No. 5 in the table below.
Command reference282