HP P9000 Command View Advanced Edition Suite Software 7.2 CLI Reference Guide

differentialManagement=false
SnapshotPoolID=-1
journalPoolID=-1
thpType=-1
consumedCapacityInKB=-1
thpPoolID=-1
threshold=-1
tcaPoolID=-1
thpPoolVolControlFlag=-1
*****: The value is encoded by the CLI.
AddLUSE
AddLUSE adds a LUSE volume to a storage system.
Make sure that you back up the data before creating a LUSE volume, because the data stored in the
LDEV/LU to be connected might be lost during creation of the LUSE volume.
When you create a LUSE volume, specify a formatted LDEV. If you include an unformatted LDEV during
creation of the LUSE volume, the LUSE volume will not be recognized from the hosts.
NOTE:
• When you add a LUSE volume with the luseoption parameter set, specify a LDEV in which a
path is set as the first LDEV. If a LDEV without a path set is specified as the first LDEV, an error
will occur.
• When a LUSE volume is added with the luseoption parameter set, the extended LUSE volume
might not be able to be recognized, based on the host. In this case, restart the host.
Parameters
Table 26 AddLUSE command parameters
DescriptionStatusParameter name
Serial number of the storage system from which LUSE is ad-
ded
Required
serialnum
Model of the storage system from which the LUSE is addedRequired
model
Comma-separated list of LDEV device numbers to create the
LUSE
This parameter can be specified in decimal, and in
colon-separated hexadecimal. If you specify a hexadecimal
number, for XP12000/XP10000/SVS200 and
XP1024/XP128, use the xx:yy format, where xx is the CU
number, and yy is the LDEV number. For P9500 and
XP24000/XP20000, use the ww:xx:yy format, where ww
is the LDKC number, xx is the CU number, and yy is the
LDEV number. ww is optional. If you omit ww, the LDKC
number is regarded as 0.
The execution results are output in decimal.
Required
devnums
CLI Reference Guide 63