HP XP7 SNMP Agent User Guide (H6F56-96013)
Table Of Contents
- HP XP7 SNMP Agent User Guide
- Contents
- 1 Introduction
- 2 Using SNMP
- 3 SNMP supported MIBs
- 4 SNMP failure trap reference
- 5 Troubleshooting
- 6 Support and other resources
- Glossary
- Index
Figure 6 Object system (3)
MIB mounting specifications
The supported MIB mounting specifications are as follows:
• mgmt OBJECT IDENTIFIER ::= {iso(1) org(3) dod(6) internet(1) 2 }
• mib-2 OBJECT IDENTIFIER ::= {mgmt 1}
An SNMP Agent mounts only system groups in mib-2, as shown in the following.
Table 9 System groups
Mounted valueDescriptionName
Fixed value. See “Object identifier system” (page 14).
1.3.6.1.4.1.116.3.11.4.1.1
This is the product identification number.sysObjectID
{system 2}
Unit: 100 msAn accumulated time from an SNMP
agent.
sysUpTime
{system 3}
Maximum 180 characters in an ASCII characters string.
Input by a user from an SNMP setting window.*
A manager who manages an agent or
a contact address.
sysContact
{system 4}
Maximum 180 characters in an ASCII characters string.
Input by a user from an SNMP setting window.*
The name of an agent managersysName {system
5}
Maximum 180 characters in an ASCII characters string.
Input by a user from an SNMP setting window.*
An agent setup location.sysLocation
{system 6}
Fixed value 76 (decimal)Value indicating a service.sysService
{system 7}
*The following symbols cannot be used: \ , / : ; * ? " < > | & % ^
Extension MIB specifications
The following shows the Extension MIB configuration.
raidExMibRoot(1)
-raidExMibName(1) SVP product name
-raidExMibVersion(2) SVP Micro-program version
-raidExMibAgentVersion(3) Extension MIB internal version
-raidExMibDkcCount(4) Number of DKC under the control of SVP
-raidExMibRaidListTable(5)List of DKC under the control of SVP
-raidExMibDKCHWTable(6) Disk control device information
-raidExMibDKUHWTable(7) Disk device information
-raidExMibTrapListTable(8)Error information list
raidExMibName
raidExMibName indicates the SVP product name.
Extension MIB specifications 15