HP XP P9000 Replication Manager Software 7.6.1-00 Configuration Guide

appagentif.properties
The appagentif.properties file is used to specify the values of properties necessary for the
interface between Replication Manager and Application Agent. Normally, you do not need to change
these values. To change the values, you need expert knowledge of Application Agent. The following
table describes the available properties and settings.
Table 54 List of properties in the appagentif.properties File
DescriptionProperty
The amount of time Replication Manager waits to connect to an
Application Agent when collecting configuration statuses. If 0 is
specified, Replication Manager waits until a connection is
established without timing out.
Specifiable values: 0 to 3600 (seconds)
Default value: 30
appagentif.connectTimeout
The amount of time Replication Manager waits to receive a
response from an Application Agent when collecting configuration
statuses. If 0 is specified, Replication Manager waits for a
response without timing out. If the specified value exceeds the
maximum, the default value is used.
Specifiable values: 0 to 86400 (seconds)
Default value: 3600
appagentif.responseTimeout
base.properties
The base.properties file is used to specify the values of properties necessary for the internal
processing of Replication Manager. The following table describes the available properties and settings.
Table 55 List of properties in the base.properties File
DescriptionProperty
Specifies whether Replication Manager automatically synchronizes with a Device
Manager database. A value of true means that automatic synchronization
occurs, and a value of false means that it does not.
Specifiable values: true or false
Default value: true
base.repositry.syn-
chronize.polling
The interval at which Replication Manager checks whether a task related to a
copy pair operation has finished.
Specifiable values: 30 to 3600 (seconds)
Default value: 120
base.taskscheck.in-
terval
The maximum number of times that Replication Manager checks whether a task
related to a copy pair operation has finished. If 0 is specified, there is no limit.
Specifiable values: 0 to 100 (times)
Default value: 0
base.taskscheck.max-
count
Configuration Guide 105