HP XP P9000 Replication Manager Software 7.6.1-00 Configuration Guide

6. In the Cluster Administrator window, right-click the group in which the HDvM service
(DeviceManagerServer) is registered, and choose Move Group to switch the node to the executing
node.
7. In the Cluster Administrator window, right-click the group in which the HDvM service
(DeviceManagerServer) is registered, and choose Online.
Using the hcmdsdbclustersetup command
If there are no P9000 Command View AE suite products in a cluster configuration on the same host,
execute the command shown below. This command changes the port number of the port used by
HiRDB to the default port number (23032). If you changed the port number to a number other than
the default, note the port number being used so that you can specify it later.
In Windows:
Common-Component-installation-folder\bin\hcmdsdbclustersetup /createcluster
/databasepath database-re-creation-folder /exportpath
target-folder-for-storing-database /auto
For database-re-creation-folder, specify a folder on the shared disk. For
target-folder-for-storing-database, specify a folder on the local disk. (Before executing
the command, be sure to delete or empty these folders of any existing files. After executing
hcmdsdbclustersetup, the port number of the port used by HiRDB will be changed to the default
(23032)). The storage folder on the shared disk must have free space greater than the total volume
of the databases.
NOTE:
For database-re-creation-folder on the shared disk, the required space is the sum of the following:
• Database capacity of P9000 Command View AE Common Component
• Database capacity of all P9000 Command View AE suite products (including Replication Manager)
that are installed on the host where Replication Manager is installed
If the hcmdsdbclustersetup command fails because there is not enough space, increase the
space for that folder and re-execute the command.
Do not disconnect the shared disk from the executing node until the hcmdsdbclustersetup
command terminates normally. If the command terminates abnormally and you then restart the host,
the connection target of the shared disk might be changed to the standby node.
When the auto option is specified, the P9000 Command View AE Common Component and HiRDB
will be in the stopped state after the command is executed.
For these folders, specify absolute paths using no more than 63 bytes.
You can use the following characters to specify these folders:
A to Z, a to z, 0 to 9, ., _
You can also specify backslashes (\), colons (:), and forward slashes (/) as path delimiters. If the
auto option is specified, the command automatically stops P9000 Command View AE Common
Component and starts HiRDB. After command execution, both P9000 Command View AE Common
Component and HiRDB will not be running.
Troubleshooting134