HP XP P9000 Replication Manager Software 7.6.1-00 Configuration Guide

Adding Application Agent to the Windows Firewall Exception
list
NOTE:
This procedure is not required unless:
• You selected not to add the exceptions when prompted during the Application Agent installation
(or the process of adding the exceptions failed).
• You enabled the firewall after installing Application Agent.
• You migrated Protection Manager to Application Agent.
The Application Agent service services are as follows:
• Copy Controller
• Common Agent
To configure these services as exceptions:
1. Add the Copy Controller service to the list using this command:
Application-Agent-installation-folder\DRM\bin\util\drmaddfwlist.bat
2. Add the Common Agent service to the list using this command:
Application-Agent-installation-folder\bin\firewall_setup.bat -set
Application Agent and P9000 RAID Manager
The following sections concern the interaction of Application Agent and P9000 RAID Manager:
• Command line interface for P9000 RAID Manager, page 85
• Protection function of P9000 RAID Manager, page 85
• Using P9000 RAID Manager to configure pair volumes, page 86
• Device Manager and P9000 RAID Manager, page 86
• Starting and stopping P9000 RAID Manager, page 86
Command line interface for P9000 RAID Manager
Note the following precautions regarding using the P9000 RAID Manager command line interface:
• Do not use the P9000 RAID Manager command line interface while carrying out replica operations
from Replication Manager.
• If you use the P9000 RAID Manager command line interface to change a copy pair configuration,
be sure and refresh the system from Device Manager, followed by updating the pair configuration
and refreshing the hosts from Replication Manager.
Protection function of P9000 RAID Manager
Application Agent does not support the protection function of P9000 RAID Manager. This function
should be disabled on servers where Application Agent is installed.
Configuration Guide 85