HP XP P9000 Replication Manager Software 7.6.1-00 User Guide

TIP:

As of Replication Manager v6.3, mainframe pair status information can be obtained using Device

Manager (without HP StorageWorks P9000 for Business Continuity Manager Software or P9000

mainframe agent installed). Detailed pair state information for mainframe pairs in Device Manager

is equivalent to the information for open systems pairs shown in Table 12.

Legend:

--: Not applicable

Cnt Ac-S: Continuous Access Synchronous

Cnt Ac-A: Continuous Access Asynchronous

Cnt Ac-J: Continuous Access Journal

BC: Business Copy

1. If HP StorageWorks P9000 for Business Continuity Manager Software 5.0 is being used, the

status of the primary volume is SUSPCU, and the status of the secondary volume is SWAPPING,

the copy pair status is displayed as SUSPCU in HP StorageWorks P9000 for Business Continuity

Manager Software and Split (SW) in Replication Manager.

2. If HP StorageWorks P9000 for Business Continuity Manager Software 5.0 is being used, the

status of the primary volume is SUSPER, and the status of the secondary volume is SWAPPING,

the copy pair status is displayed as SUSPER in HP StorageWorks P9000 for Business Continuity

Manager Software and Split (SW) in Replication Manager.

3. If HP StorageWorks P9000 for Business Continuity Manager Software 5.0 is being used, the

status of the primary volume is DUPLEX, and the status of the secondary volume is SWAPPING,

the copy pair status is displayed as PENDING in HP StorageWorks P9000 for Business Continuity

Manager Software and Split (SW) in Replication Manager.

4. Suspending, Copying or Deleting (TRANS) is the actual status, but in Replication Manager

this is abbreviated as Suspending or Deleting (TRANS).

Changing copy pair status

Replication Manager allows you to change the copy pair status in open systems and mainframe

systems. Pair status change operations may be necessary to resume copy operations after recovery

from an error or unexpected pair status changes.

NOTE:

The Change Pair Status Wizard also supports site recovery operations for open systems. See “Advanced

pair operations and recovery scenarios” on page 246 for more information.