Owner's manual

Cluster interconnect
The Cluster Interconnect section displays the following information about the adapters used for
cluster interconnections:
• Network—Displays the name of the network.
• Address—Displays the address used by the interconnect in the format specified by the transport
type.
• Transport—Displays the network transport protocol used by the interconnect.
• Node—Displays the name of the system in which the adapter is installed.
• Physical ID—Displays the physical identification of the interface card including the name, the
slot number, and base I/O address, if available.
Cluster software
The Cluster Software section displays the file name, version number, and description of the HP
Insight Management Agents cluster software.
Storage agent
IDE Controllers
Select an IDE controller entry from the Mass Storage list to display a submenu containing separate
entries for IDE controller information, IDE ATA disk drives connected to the controller, and IDE
ATAPI devices connected to the controller. Device types include disks, DVD/CD-ROM drives, tape
drives, processors, scanners, optical drives, WORM drives, and so on. The following items might
appear depending on the type of controller:
• IDE controller information
• IDE ATAPI devices
• IDE ATA disk drives
• IDE ATA logical drives
IDE controller information
Select a controller entry from the Mass Storage list to display the following information:
• Model—Displays the controller’s model string, used for identification purposes
• Slot—Displays the physical slot number where the controller is installed in the system or N/A
if slot number is not available
• Firmware Version—Displays the firmware version of the controller
IDE ATAPI devices
The information displayed for each IDE ATAPI device entry in the submenu includes condition
graphic and device location: Primary or Secondary channel, Master device 0 or Slave device 1.
If the Storage Agents cannot determine the channel then “Channel unknown” displays. If the device
position cannot be determined, “Device unknown” displays and the driver software or the Storage
Agents might need to be updated. Select any of the devices from the submenu to display more
information about the devices. The following information displays for all devices:
• Device Type—Identifies the type of ATAPI device. The following values are valid:
Disk—A direct-access device, such as a disk drive.◦
◦ Removable Media Disk—A removable media device, such as a floppy disk drive.
◦ Tape—A sequential-access device, such as a tape drive.
30 Agent information