Installation and Upgrade Guide

Installing the G06.24 RVU
G06.24 Software Installation and Upgrade Guide—528593-005
5-10
Create a New Software Revision
.
DSM/SCM returns you to the Target Information dialog box.
4. Click OK to return to the Configuration Revisions dialog box.
5. Click OK to return to the Planner Interface.
6. Select New software revision.
DSM/SCM opens a New software revisions dialog box that shows the products in
the last software revision that was built for the target system. It might take several
minutes for the dialog box to appear.
a. In the New software revision dialog box, click Edit revision notes.
A Revision Notes text box containing existing revision notes appears.
Note. If you receive this error message stating that the current target is pre-D46, you can
continue with the installation if you are certain that you have installed the DSM/SCM
T6031D46 PVU or later SPR. To check the correct product version:
1. Use the following DSM/SCM VPROC commands:
> volume $dsmscm_vol.ZDSMSCM
> vproc taexe
> vproc cbexe
2. Log on to TI by running ZPHITI (page 5-19). The current target version appears.
> RUN ZPHITI
3. To continue with the installation, click OK.
If you have previously installed the D46 DSM/SCM PVU and created a snapshot, the error
message does not appear.