Installation and Upgrade Guide

Installing the G06.24 RVU
G06.24 Software Installation and Upgrade Guide—528593-005
5-16
Build and Apply the New Software Revision
6. Edit the instructions to provide the correct (new) SYSnn number, and then click
OK.
The Planner Instructions box closes.
7. Select the Scheduling, Output, SYSGEN, TSV Location, and File Placement
options and configure as appropriate for your system. (See the DSM/SCM User’s
Guide or the online help for more information about Build/Apply Request options.)
In particular, you might want to create a system image tape (SIT) during the
Build/Apply. For example:
8. Confirm that the spooler is active and not 100 percent full before executing the
Build/Apply request. At a TACL prompt, start SPOOLCOM and issue a COLLECT,
STATUS command. For example:
12> spoolcom $spls; collect, status
COLLECT STATE FLAGS CPU PRI UNIT DATA FILE %FULL
$S ACTIVE 3 , 1 154 4 $OPS0.SPL.DATA 4
9. In the Build/Apply Request dialog box, click OK.
DSM/SCM runs the Build and Apply steps and displays a Status window, which is
automatically updated at regular intervals. For example: