Installation and Upgrade Guide

Installing the G06.24 RVU
G06.24 Software Installation and Upgrade Guide—528593-005
5-21
Print Operator Instructions From the Target Interface
(ZPHITI)
An example might look like this:
Activation Instructions for \WARRIOR DEFAULT
These are general instructions that were determined from configuration
attributes. Refer to the release documentation for detailed information
on migrating to this software configuration.
1. Stop all applications. Keep OSS running.
2. Update FIRMWARE.
Run TMDS (or TSM for S-Series) to check firmware and perform
firmware updates.
T7892 S70000 BOOT MILLICOD includes firmware changes.
T1089 S-SERIES SP FW includes firmware changes.
3. RUN ZDSMSCM.ZPHIRNM SYSnn
(Note: replace nn with correct number)
4. Check for $0 EMS messages.
Correct any errors indicated in the $0 EMS messages.
Do not proceed until this step has been successfully completed.
5. Coldload is required.
6. Run merge_whatis if ZPHIRNM indicates it is needed.
7. Restart all applications.
7. Press SF16 to exit the Target Interface.
In the Activation instructions, you might see information regarding the merge_whatis
OSS command.
Run merge_whatis if zphirnm indicates it is needed.
When you finally run ZPHIRNM, the following lines are written to the log:
Note: merge_whatis needs to be run to update the man pages.
Files in a whatis.frag directory have changed.
The merge_whatis is a shell script in /bin. It creates and updates the whatis
database used by the OSS shell man, apropos, and whatis commands. You must
run the merge_whatis command once against each directory that contains the man
page files to be used.
You will run merge_whatis after using ZPHIRNM. Running the merge_whatis
command is documented in Steps for Running ZPHIRNM on page 10-5.
Note. If the operator instructions require you to run the INSTALL^TEMPLATES macro, see If
Running INSTALL^TEMPLATES Is Required on page A-7 for detailed instructions.