Installation and Upgrade Guide

Updating Service Processor (SP) Firmware
G06.24 Software Installation and Upgrade Guide—528593-005
7-12
Update SP Firmware Using the TSM Service
Application
16. Verify that the correct firmware version is loaded for each SP:
a. If necessary, log on to the TSM Low-Level Link Application and perform a
System Discovery. (Do not log off the TSM Service Application.)
b. Display the Service Processor Actions dialog box, either by clicking SP
Actions in the toolbar or by selecting Display>SP Actions.
c. Check that the firmware version and date appear in the Service Processors
(SPs) list.
d. Click Refresh to update the information in the Service Processors (SP) list.
This step might take several minutes.
e. Verify that the correct version of SP firmware is displayed in the Service
Processors (SPs) list:
•
The service processor is successfully updated and reset if the firmware
version and date for all SPs in the chosen fabric are exactly the same as
the VPROC version of the SP firmware for the G06.24 RVU.
•
A service processor in the chosen fabric did not successfully update or
reset if it has a firmware version and date that are not exactly the same as
the VPROC version of the SP firmware for the G06.24 RVU.
Follow the directions in Recovery for Problems Updating SP Firmware
(Using TSM) on page 7-15 before you proceed to update the service
processors in the other fabric. Every SP on the chosen fabric must be
successfully updated and reset before updating the SPs on the other
fabric. This step is necessary to ensure that the firmware is operating
properly.
17. After you have verified that the correct version of SP firmware appears in the
Service Processors (SP) list for the service processors in the chosen fabric, return
to the TSM Service Application and repeat Steps 5 through 16 for the service
processors in the other fabric.
The firmware version for all SPs should now show the latest version. This example
shows T1089G06^ABI: