Installation and Upgrade Guide

Updating Service Processor (SP) Firmware
G06.24 Software Installation and Upgrade Guide—528593-005
7-18
Resetting an SP Using the TSM Low-Level Link
6. When the SP update finishes successfully, reset it, as described under Resetting
an SP Using the TSM Low-Level Link on page 7-18.
See the TSM Low-Level Link Application online help for more information.
Resetting an SP Using the TSM Low-Level Link
To reset an SP, use the TSM Low-Level Link Application:
1. Log on to the TSM Low-Level Link Application and perform a System Discovery.
2. From the toolbar, click SP Actions to display the Service Processor Actions dialog
box.
3. Select the service processor to be reset.
4. From the Available Actions list, select Reset.
5. Click Perform Action.
6. Click OK when the warning message appears.
This action takes up to 2 minutes for the SP to complete the reset even if the action
appears to complete immediately.
This action will cause any Firmware Update actions against this SP to abort.
Verify there are no Firmware Updates being performed on this SP before continuing.
Are you sure you want to reset this SP?
7. When the status of the reset action appears as Completed in the Action Status
box, click Refresh to update the information in the Service Processors (SPs) list.
For example:
WARNING. To avoid hardware damage, never reset an SP if the firmware update does not
finish successfully.