Installation and Upgrade Guide

G06.24 Software Installation and Upgrade Guide—528593-005
xiii
What’s New in This Manual
Manual Information
G06.24 Software Installation and Upgrade Guide
Abstract
This manual provides detailed procedures for upgrading an HP NonStop™ S-series
server to the G06.24 release version update (RVU) from any G06.06 or later RVU.
Product Version
N.A.
Supported Release Version Updates (RVUs)
This publication supports the G06.24 RVU only.
Document History
New and Changed Information
The following summarizes major changes in this.005 edition:
•
With the introduction of the G06.24 RVU and the new boot code firmware
(T7892ABD) needed for the S88000 processor, potential system problems can
result if you upgrade the boot millicode and you not have the G06.24 OSM or TSM
SPRs installed. See Section 8, Updating Processor Boot Code
. See also the
G06.24 RVU upgrade checklist in Section 2, G06.24 Upgrade Checklists.
•
New information regarding OSS SPRs used to configure OSS as a persistent
process can be found in OSS (G06.12 through G06.24) on page 1-25.
•
New instructions are provided for installing EMS templates. See If Running
INSTALL^TEMPLATES Is Required on page A-7 and If Running
INSTALL^TEMPLATES Is Required on page B-13.
•
A missing step has been added in Appendix C, Updating SWAN Concentrator
CLIP Firmware, in Using the SWAN Fast Firmware Update Guided Procedure
(Recommended if Using TSM).
Part Number Published
528593-005 January 2005
Part Number Product Version Published
528593-005 NA January 2005
528593-004 NA October 2004
528593-003 NA August 2004
528593-002 NA August 2004