Installation and Upgrade Guide

Updating Processor Boot Code

G06.24 Software Installation and Upgrade Guide—528593-005

8-3

Before You Begin Updating the Boot Millicode

Check Processor Status

Before you update your firmware, verify that the system is up with at least one

processor running a G06.00 or later version of the NonStop operating system:

1. If necessary, log on to the OSM or TSM Low-Level Link Application.

2. From the TSM or OSM toolbar, click Processor Status.

Processor status should be Executing NonStop OS.

Verify Your TSM and OSM Versions

See Determining the Current Version of OSM on page 3-9 and Determining the Current

Version of TSM Server Software on page 3-10.

Verify Location and Version of Processor Boot Code

1. At a TACL prompt, issue the VPROC command to verify the location and version of

the processor boot code for the G06.24 RVU:

•

For processor boot code for the NonStop Server S7000, enter:

>VPROC $SYSTEM.SYSnn.CPUCODE8

•

For processor boot code for NonStop servers S7x000, S8x000, S7400, S7600,

S7800, or S78000, enter:

>VPROC $SYSTEM.SYSnn.CPUCODE9

where nn is the number specified during the Build/Apply phase when you installed

the G06.24 RVU.

(\itty $SYSTEM.SYS05 7> vproc cpucode9

VPROC - T9617G03 - (07 AUG 2003) SYSTEM \ITTY Date 16 NOV 2004, 17:07:52

$SYSTEM.SYS02.CPUCODE9

Binder timestamp: 24AUG2004 10:22:35

Version procedure: T7892G07^23AUG04^ABD^24Aug04^

\itty $SYSTEM.SYS10 6> vproc cpucode8

VPROC - T9617G03 - (07 AUG 2003) SYSTEM \ITTY Date 16 NOV 2004, 17:07:41

$SYSTEM.SYS10.CPUCODE8

Binder timestamp: 13OCT2000 10:23:06

Version procedure: T8461G05^12OCT00^12Oct00

Note. Version procedure dates might be different; these are examples only. Bold lettering

is used to emphasize the vproc command and corresponding results.