Installation and Upgrade Guide

Updating Processor Boot Code
G06.24 Software Installation and Upgrade Guide—528593-005
8-10
Method 2: Using Your Current Pre-G06.24 OSM or
TSM SPRs, Update the Processor Boot Code and
Method 2: Using Your Current Pre-G06.24 OSM
or TSM SPRs, Update the Processor Boot
Code and Issue a Hard Reset or Equivalent
•
Using TSM, Update the Processor Boot Code and Issue a Hard Reset or
Equivalent on page 8-10
•
Using OSM, Update the Processor Boot Code and Issue a Hard Reset or
Equivalent on page 8-14
Using TSM, Update the Processor Boot Code and Issue a Hard
Reset or Equivalent
From the TSM Service Application, use the Firmware Update dialog box to update the
processor boot code offline for each PMF CRU in your system:
1. Log on to the TSM Service Application.
2. Select Display>Firmware Update.
The Firmware Update dialog box appears.
3. From the Resource Type list, select Processor Boot Code, Y-side.
4. From the Display list, select All to list the selected resources in the Available box:
Note. You can also perform a hard reset using the TSM or OSM Low-Level Link on all
processors when you perform a system load instead of using the Reset action. See The Reset
Operation on page 11-8.