Installation and Upgrade Guide

G06.24 Software Installation and Upgrade Guide—528593-005
9-1
9
Updating SCSI Boot Code
(Pre-G06.08 RVU)
This section describes how to check and, if necessary, update SCSI boot code for
each PMF CRU in your system.
•
Using TSM to Update SCSI Boot Code (If Necessary) on page 9-2
•
Using OSM to Update SCSI Boot Code (If Necessary) on page 9-4
SCSI Boot Code Product Numbers
Use these SCSI boot code product numbers for the PMF CRUs to verify that the
update to the new version is successful:
Note. Update SCSI boot code only:
•
If instructed to do so by DSM/SCM
•
If you are not replacing the PMF CRUs in your system while migrating to the G06.24 RVU.
Note. If you are migrating to the G06.24 RVU from an RVU prior to G06.08, you must update
SCSI boot code after you perform the system load of the G06.24 RVU so that the TSM server
software uses the default ISP firmware file IBOOT (introduced with the G06.08 RVU).
OSM can be installed only on G06.08 RVUs or later.Therefore, the IBOOT (T0503) file should
already be installed. Instructions are provided when a new firmware file is introduced.
RVU
Released
Product Number
Object
Product Number File Name
G06.07 and earlier T1067 T1067 I1000
G06.08 and later T0503 T1067 and T0480 IBOOT