Installation and Upgrade Guide

Updating SCSI Boot Code (Pre-G06.08 RVU)

G06.24 Software Installation and Upgrade Guide—528593-005

9-2

Using TSM to Update SCSI Boot Code (If

Necessary)

Using TSM to Update SCSI Boot Code (If

Necessary)

Before you update your firmware, verify that the system is up and running the G06.24

version of the NonStop Kernel operating system. This step is important if you are

coming from a pre-G06.08 RVU.

1. If necessary, log on to the TSM Low-Level Link Application.

2. On the toolbar, click Processor Status.

3. The Processor Status should be Executing NonStop OS.

4. At a TACL prompt, use the VPROC command to verify and record the location and

version of the SCSI boot code for the G06.24 RVU:

>VPROC $SYSTEM.SYSnn.IBOOT

where nn is the new operating system image subvolume. For example:

$SYSTEM SUPER 1> vproc $system.sys02.iboot

VPROC - T9617G03 - (30 MAR 1999) SYSTEM \WARRIOR Date 21 SEP 2000, 13:50:43

$SYSTEM.SYS02.IBOOT

Binder timestamp: 11MAY2000 13:22:07

Version procedure: T1067F40^05MAR00^TREV=01^AAN

Version procedure: T0480G06^11MAY00^TREV=01^AAA

Note that the version procedures for I1000, I1040, and IBOOT do not have to match.

From the TSM Service Application, use the Firmware Update dialog box to update the

SCSI boot code for each processor multifunction (PMF) customer-replaceable unit

(CRU) in your system.

1. Select Display>Firmware update to display the Firmware Update dialog box.

2. From the Resource Type list, select SCSI Boot Code, Y-side.

3. From the Display list, select All to list the selected resources in the Available box.

For example:

Note. Version procedure dates might be different; these are examples only.