Installation and Upgrade Guide

Running ZPHIRNM
G06.24 Software Installation and Upgrade Guide—528593-005
10-5
Steps for Running ZPHIRNM
The syntax for running ZPHIRNM in PREVIEW mode is (from the DSM/SCM
subvolume):
> RUN ZPHIRNM [$vol.]SYSnn , PREVIEW [STRICT] [,option] ...
If you enter a RUN ZPHIRNM command with no arguments, ZPHIRNM help text
displays information about PREVIEW mode. For more information, see the DSM/SCM
User’s Guide.
Steps for Running ZPHIRNM
1. At a TACL prompt, enter this command from the DSM/SCM subvolume:
> RUN ZPHIRNM $vol.SYSnn
where:
•
$vol specifies the default current system load volume, usually $SYSTEM.
•
SYSnn specifies the subvolume to which you just applied software. The SYSnn
subvolume must match the activation SYSnn that you specified earlier during
the Build/Apply phase.
2. When asked if you want to use a log file with the session, enter Y.
3. When prompted, enter a file name for the log file.
For example:
6> run zphirnm $system.sys00
DSM/SCM Utility - ZPHIRNM - T6031D31 - (31MAY2001)
Copyright Compaq Computer Corporation 1993-2001
Do you want to use a log file with this session? (Y/N): y
You may use any file for logging. If you request to use a disk
file that doesn't exist, it will be created as an edit file.
Please enter a filename: elist00
Log file is open, Zphirnm will now begin processing.
ZPHIRNM begins processing and provides status of its progress.