Installation and Upgrade Guide

G06.24 Software Installation and Upgrade Guide—528593-005
12-1
12 Resuming Normal Operations
Several tasks must be performed after system load before you can resume normal
system operations, as described in this section.
•
Update TCP/IP Configuration Files
•
Check Processor Status (Using TSM or OSM)
•
Perform Other Firmware Updates
•
Configure the Spooler
•
Start User and System Applications
•
Reset and Start the Mirror System Disk (If Necessary)
•
Configure Specific Products (Post-System Load)
Update TCP/IP Configuration Files
Step 1: Copy the Sample TCP/IP Files into $SYSTEM.ZTCPIP
(Optional)
You need to copy the sample files if you do not have any of the following TCP/IP
configuration files in your $SYSTEM.ZTCPIP subvolume:
•
HOSTS
•
PROTOCOL
•
NETWORKS
•
PORTCONF
•
RESCONF
•
SERVICES
Note. You must have all the TCP/IP configuration files in your $SYSTEM.ZTCPIP subvolume.
Otherwise, applications dependent on proper network connections will fail.
Alerts:
•
See Back Up (Copy) Files in the $SYSTEM.ZTCPIP Subvolume on page 10-2.
•
For the DSM/SCM Planner Interface to be operational, the PORTCONF file must have the
correct entry for DSM/SCM. The SERVICES file must have an entry that specifies DSM
and its corresponding port number.
•
Keep your current PROTOCOL file in your $SYSTEM.ZTCPIP subvolume. Update it with
the new lines from the sample PROTOCOL file (SMPLPROT).