Installation and Upgrade Guide

Loading the Previous RVU and Resuming Normal
Operations
G06.24 Software Installation and Upgrade Guide—528593-005
17-2
Prepare to Stop the System
Prepare to Stop the System
Before halting the processors:
1. Stop all user applications.
2. Stop TMF and DSM/SCM. For example:
5> TMFCOM STOP TMF
6> VOLUME $dsmscm_vol.ZDSMSCM
7> RUN STOPSCM
Halt the Processors
Halt all processors from the TSM Low-Level Link Application or from the OSM
Low-Level Link.
Remove Hardware Installed During Migration
If you installed or replaced hardware during your migration to the G06.24 RVU, you
might have to remove it before loading your previous RVU. For example:
•
NonStop S74000 processors are not supported prior to the G06.08 RVU.
•
NonStop S76000 and S86000 processors are not supported prior to the G06.16
RVU.
•
NonStop S7800 and S78000 processors are not supported prior to the G06.16
RVU.
•
NonStop 88000 processors are not supported prior to the G06.24 RVU.
•
GESAs are not supported prior to the G06.16 RVU.
•
SWAN 2 servers are not supported prior to the G06.16 RVU.
•
Disconnect the IOAM and its components, which are supported only on G06.24
and later RVUs.
See the appropriate RVU-specific hardware documentation for additional information.