Installation and Upgrade Guide

Using DSM/SCM to Install SPRs
G06.24 Software Installation and Upgrade Guide—528593-005
A-6
Print Operator Instructions From the Target Interface
(ZPHITI)
This step updates the Software in Archive window to show the newly received
software.
8. Exit the DSM/SCM Planner Interface.
Print Operator Instructions From the Target
Interface (ZPHITI)
1. Make sure that spooler is active.
2. On the DSM/SCM subvolume, type:
RUN ZPHITI
The TI Logon screen appears.
3. Type your user ID and password and press F1 to log on to the Target Interface.
The Main Menu appears.
4. Type 3 (Perform target activities) in the Selection number field and press F1.
The Target Menu - Select Target screen appears.
5. In the Selection number field, type the number corresponding to the logical target
on which the new software was applied and press F1.
The Target Menu - Select Action screen appears.
6. In the Selection number field, type 3 (Review operator instructions for the last
apply completed) and press F1 to display the operator instructions.
7. Type a printer location in the Print operator instructions field and press F9 to print
the operator instructions.
Run ZPHIRNM
During the Build/Apply phase, DSM/SCM places product files in their subvolumes with
temporary (fabricated) file names so that the new files do not conflict with the file
names of currently running programs. After the Build/Apply finishes, run the ZPHIRNM
program on the target system to:
•
Rename the files that currently have actual file names with fabricated names.
These files become obsolete when the new files are renamed.
•
Rename the new files, which have fabricated names, with their actual names.
1. At a TACL prompt, enter the following command from the DSM/SCM subvolume:
> RUN ZPHIRNM $vol.SYSnn
where: